For High Wind HIL tests were carried out for the Boom Lock control system.
Read More ...
Controllab has been involved in developing a Training Simulator for Mammoet.
For Thales a model was developed to investigate the dynamics of buoys.
For Huisman research was done into the use of HIL-testing for automatic testing of PLC code.
Controllab helped Klöcker to increase the speed of their ultra-fast stepper motors.
The company Allseas has the largerst fleet of pipelaying ships in the world.
Mecal creates machine support frames for the semiconductor industry.
For Rolls-Royce Marine a HIL-tester for a launch and recovery system has been developped.
Kwant is one of the world’s leading manufacturers of high end nautical controls and systems.
Lansmont used 20-sim to develop the drive system for a horizontal impact tester.
For Aker Solutions, the University of Agder has developed a HIL simulator.
Machine control using feed forward (FF) can enhance the positioning and tracking.
At the University of Twente a passive dynamic walking robots has been designed.
KGAL was commisioned to design the hydraulic drives of a swing bridge.
Modeling a hydraulic controllable gearbox to drive the dredge pump on board of a hopper dredger.
Ingenieursbureau Albers specializes in the advise on hydraulic circuits.
Stork has developed a towing tank for the Depressurized Wave Basin of Marin.
Read more ...
Nefit builts heaters with a modulating pump for the primary water flow circuit.
Stork has developed a crane module to act as a towing tank in the Sea basin of Marin
The Dutch Marin Institute uses large facilities to test ship models in all kinds of conditions.
Page 1 of 2
Controllab Products , Hengelosestraat 500 , 7521 AN Enschede , the Netherlands (map)
Tel: +31 (0)85 773 18 72 , Chamber of Commerce: 06076204 , VAT: NL803694167B01